Please find here the most frequently asked questions regarding liberoCONFIG.
Content
What are the system requirements for liberoCONFIG?
Where can I download liberoCONFIG?
I did not receive the e-mail with the license key/download link
Could the same license key be used more than once?
Which rights are required during installation?
Could multiple instances (versions) of liberoCONFIG be installed/run on one computer?
Where can the operational manual be found?
How do I put LIBERO data logger into configuration mode?
What is liberoCONFIG?
liberoCONFIG is a free software to configure the LIBERO PDF data loggers. It allows the user to define all configuration parameters and save them as profiles. A profile contains all settings for the monitoring task and is summarized in the PDF report generated by the logger, or in a special configuration report, which can be generated in liberoCONFIG.
The configuration of a single LIBERO Cx is done with liberoCONFIG. SmartStart Pack & Go can be used to quickly and securely assign a profile to a larger number of LIBEROs.
SmartStart Pack & Go .exe files can be used on any PC without installation and without special drivers.
Further information could be found in the operational manual from chapter 6 / page 10 onwards.
What are the system requirements for liberoCONFIG?
The system requirements can be found in the operational manual from chapter 6 / page 10 onwards.
Where can I download liberoCONFIG?
You can download the software at https://software.elpro.com/. After filling in the mandatory fields, you will receive an e-mail with the download link to the software. The e-mail also contains the license key, which you must enter during installation.
I did not receive the e-mail with the license key/download link.
Please check your e-mail folder "Spam". It could happen that the e-mail with the download link is automatically moved there.
If you still do not receive an e-mail, please check your mail configuration in consultation with your IT. It is possible, that our server is blocked as a sender.
Could the same license key be used more than once?
No, each license key can be used only once. However, you can download the software as often as you want. After filling in the mandatory fields at https://software.elpro.com/, you will receive a new license key by e-mail each time.
Which rights are required during installation?
You need "admin rights" to install liberoCONFIG on your PC/laptop. If you do not have these, please contact your IT.
Could multiple instances (versions) of liberoCONFIG be installed/run on one computer?
No, only one installation per computer can be performed and thus also executed.
Where can the operational manual be found?
The configuration options always depend on the logger type used. Therefore, you will find the operational manual in the respective logger-specific instructions.
How do I put LIBERO data logger into configuration mode?
- LIBERO W:
Press and hold the two buttons on the base station until "Config" appears on the display. You now have approx.10 seconds to connect the base station to the USB port of your PC/laptop, before the display jumps back again. In this case press and hold the two buttons again. - For multi-use devices (LIBERO CE/CL/CH):
If the logger is already in use and you would like to change the configuration; Stop the recording - the display shows "make PDF". Only after connecting the logger to the USB port, creating the PDF report and saving it on your PC/laptop, "Stop" appears on the display.
Only if the display shows "Stop" you could reconfigure the device with liberoCONFIG. - All other LIBERO data loggers:
At delivery the devices are in configuration mode and can be connected directly to the PC/laptop and configured with liberoCONFIG, the display shows STRT or CNFG.